3 Axis Plastic Dome, MPEG4 / JPEG Network Camera

Manual
Software


¡á Network Camera
I-421 I-422 I-425 I-426
  • 1/3" SONY Super HAD CCD
  • Color 480 TV Lines
  • 0.3 Lux / F2.0
  • Board Lens
  • ¥Õ120 DOME SIZE
  • 3 Axis Bracket
  • 1/3" SONY Super HAD CCD
  • Color 480 TV Lines
  • 0.3 Lux / F2.0
  • DC Auto Iris
  • Vari-focal lens 4.0~9.0mm
  • ¥Õ120 DOME SIZE
  • 3 Axis Bracket
  • 1/3" SONY Super HAD CCD
  • Color 550 TV Lines
  • 0.3 Lux / F1.2 (Sens-up X128 : 0.002 Lux)
  • DNR
  • Board Lens
  • ¥Õ120 DOME SIZE
  • 3 Axis Bracket
  • 1/3" SONY Super HAD CCD
  • Color 550 TV Lines
  • 0.3 Lux / F1.2 (Sens-up X128 : 0.002 Lux)
  • DNR
  • DC Auto Iris
  • Vari-focal Lens 4.0~9.0mm
  • ¥Õ120 DOME SIZE
  • 3 Axis Bracket
    • CryptoTelecom
  • Dual Compression (MPEG4 encoder 1ea, JPEG encoder 1ea) : Independent resolution, frame rate and bit rate video compression (30fps @ NTSC, 25fps @ PAL)
  • Dual Streaming (MPEG4 stream 1ea, JPEG stream 1ea) : Independent resolution, frame rate and bit rate video streaming
  • 4 Resolution Selectable : D1, Half D1, 2CIF, CIF
  • CBR/VBR selectable (CBR : 100kbps ~ 5Mbps / VBR : low, normal, high)
  • Built-in de-interlace filter for clean and clear video
  • Full duplex voice communcation : G.723 (ADPCM), microphone input, speaker output
  • Various free softwares for PCs, PDAs and mobile phones
  • 50 Concurrent Access
  • Event based automatic or manual control of relay output (open / short control)
  • Encryption of ID, password, video, audio and data
  • Alarm by e-mail & SMS in case of event (video loss, motion and sensor triggering)
  • Pre-alarm and Post-alarm video recording in the PIMA server in case of event (motion and sensor triggering)
  • Intelligent motion detection and alarm triggering
  • DDNS and all IP addresses (Global, Private, Dynamic and Static IP address) supported
  • Multi-level user ID & password
  • Encryption of user ID/password, video, audio, data
  • Remote configuration and status using web-based tool
  • Firmware upgradable for future proof
  • User web page uploadable into the network camera
  • Embedded Linux
  • ARM9
  • FLASH memory : 16MB
  • SDRAM : 64MB
  • PoE : optional
  • IPv6 : optional


    • ¡á General Description
    The network camera consists of an analog camera module and a network A/V server module (S-3838), which is an extremely small (38mm x 38mm) and high performance MPEG4/JPEG network A/V server board with a built-in de-interlace filter which makes and provides artifact free and superior video (clean and full D1 30fps MPEG4 / JPEG) just like a progressive network camera. Depending on the model of the network camera, the network camera may have an analog video output, two sensor inputs, a relay output, an analog audio input and an analog audio output, a factory reset, an RS-485 port and an RJ-45 port. The nework camera is provided with many free softwares. PoE and/or IPv6 enabled network cameras are available.

    ¡á Video
    Resolution
  • NTSC :704x480, 704x240, 352x480, 352x240
  • PAL: 704x576, 704x288, 352x576, 352x288
    • Frame Rate
  • Maximum Frame Rate : 30fps@NTSC, 25fps@PAL
  • NTSC : 1, 2, 3, 4, 5, 6, 7, 10, 15, 30 (Frame Control)
  • PAL : 1, 2, 3, 4, 5, 6, 7, 8, 12, 25 (Frame Contorl)
    • Bit Rate
  • CBR/VBR selectable
  • CBR : 100kbps ~ 5Mbps
  • VBR : low, normal, high
    • Compression
  • Triple Compression (MPEG4 encoder 2ea, JPEG encoder 1ea) : Independent resolution, frame rate and bit rate video compression
  • MPEG4 compression : Max. 30fps@NTSC, Max 25fps@PAL for each MPEG4 encoder
  • JPEG compression for mobile monitoring
    • Streaming
  • Triple Streaming (MPEG4 stream 2ea, JPEG stream 1ea) : Independent resolution, frame rate and bit rate video streaming
  • MPEG4 streaming : Max. 30fps@NTSC, Max 25fps@PAL for each MPEG4 stream
  • JPEG streaming for mobile monitoring

    • ¡á Audio
  • Direction : Full Duplex (Microphone/Speaker Port support)
  • Compression : G.723 (ADPCM)

    ¡á Event & Alarm
  • Pre-alarm Buffer : Max. 10 seconds
  • Post-alarm Buffer : Max. 20 seconds
  • Motion Detection : Motion Vector Based
  • Sensor Input Detection
  • Video Loss Detection

    ¡á Security
  • Administrator ID/Password : Managing of users and Configuration of the network camera
  • User ID/Password : Multi-level user ID/password
  • Encryption : Encrypted user ID/password, Video, Audio, Data

    ¡á Network
  • Physical Layer : 10BaseT/100BaseTX Ethernet
  • Protocol : TCP/IP, HTTP, FTP, SMTP, NTP, ARP, DDNS, DHCP
  • IP support : Dynamic IP, Static IP, Global IP, Private IP
  • DDNS Available in the PIMA server (http://www.pima1.net)

    ¡á Management
  • Remote Administration : Remote configuration and status using web-based tool
  • System Firmware Update : Remote system firmware update over network using web client
  • User web page uploadable into the network camera

    ¡á Software



    ¡á Interoperable Products
    The network camera is interoperable with the following products.

  • Network A/V Clinet : C-3838
  • Relay Server
  • PIMA Server

    ¡á Physical
  • Operational Temperature : -10 degree ~ 50 degree

    ¡á Functions of I/O
    I/O Function
    Factory reset If the factory reset is pushed while the power is on, all the parameters of the network will be initialized to the same values as the network camera was initialized in the factory.
    Sensor input A sensor can be connected to the sensor input, which can be normal open or close depending on the setup at the administrator's page of the network camera.
    Relay control output A relay can be connected to the relay control output.
    Video output The video output of the network camera is the analog video output from the built-in analog camera which can be connected to the video input of a CCTV monitor, a DVR and a VTR.
    Audio input A microphone can connected to the audio input.
    Audio output A speaker can connected to the audio output of which audio comes via a network such as a LAN and the internet.
    RS-485 port An RS-485 device such as a pan/tilt/zoom module can be connected to the RS-485 port.
    RJ-45 port A LAN cable can be connected to the RJ-45 port.